PVC wood grain edge banding

Views : 504
Author : Nancy
Update time : 2020-03-06 11:32:46
PVC wood grain edge banding
Cured after printing with ink on a PVC substrate and roll coating with UV paint
Woodgrain edge bands must show good simulation results in the quality of the ink. Using high-quality ink to print the edge band, the simulation effect of the edge band is close to that of the board, the printing layer is rich, and the indoor discoloration is not obvious within three years. At present, the edge bands with rich layering are mainly three-color printing, followed by two-color printing and one-color printing.






 
Detection method: Put the edge bands printed with different inks under strong sunlight for a week, and then compare with the sunlight before irradiation, you can see that the faded degrees of the two edge bands are different. The abrasion resistance and transparency of wood grain edge strips are related to the quality of UV paint. If the surface of the edge band is easily scratched or blurred, it is due to the use of poor quality UV paint. The degree of adhesion between the edge band and the board, and the adhesion effect of the edge band and the hot melt depend on the quality of the adhesive.
There is a certain temperature requirement for the adhesion of the board and the edge band. Although the temperature of the hot-melt in the hot-melt bucket of the edge banding machine is 200 ℃ —— 180 ℃, there is a distance of 20CM —— 30CM from the bonding point of the hot-melt roller to the edge band. Due to the low temperature in the workshop and the rapid heat dissipation, the temperature of the bonding point between the board and the edge band is actually below 120 ° C, so the bonding effect is not ideal. At this time, if the bad adhesive is used again, it is easier to open the glue.
















 
Solution: Because the sheet is used to cut the saw from a low-temperature place, the temperature of the side of the sheet will be too low to affect the bonding effect. Therefore, the indoor temperature of the workshop should be above 15 ℃ and add a thermostat to the edge banding plate of the edge banding machine.
 
Related News
Read More >>
What are the characteristics of environmentally friendly edge sealing hot melt adhesives? What are the characteristics of environmentally friendly edge sealing hot melt adhesives?
Oct .20.2022
The solid content is 100%, and it has void filling properties, which avoids the defects such as deformation, dislocation and shrinkage of the adhered parts caused by edge curling, air bubbles and cracking.
Appearance And Prospect Of Edge Sealing Hot Melt Adhesive Appearance And Prospect Of Edge Sealing Hot Melt Adhesive
Sep .22.2022
Environmentally friendly edge sealing hot melt adhesive is a green and pollution-free environmental friendly adhesive.
What kinds of situations often occur when hot melt adhesive particles are used in furniture edge sealing? What kinds of situations often occur when hot melt adhesive particles are used in furniture edge sealing?
Aug .26.2022
1. Black edge phenomenon: The hot melt machine has not been cleaned for a long time, and the glue itself has carbonization phenomenon.
Reasons for the open edge of the edge band Reasons for the open edge of the edge band
Aug .13.2022
The moisture content of the edge banding wood is unqualified (>18%), and the natural drying during the use of the door leaf produces internal stress, resulting in cracking and deformation of the edge banding.